09

2022

-

09

Preparation for installation of high-lift deep well pump

Classification:


Everyone knows that the structure of the high-lift deep well pump is relatively simple, and it is also convenient to maintain, the volume is relatively small, and the mass is very clean energy. So in the process of using it, if there are some failures, how should we troubleshoot it. Then we can take a look at what should be prepared before the installation of this high-lift deep well pump. First, we must clean up the space and take out all the equipment, tools and other items.

Everybody knowshigh lift deep well pumpThis structure is relatively simple, and it is also convenient to maintain, the volume is relatively small, and the mass is very clean energy. So in the process of using, if there are some failures, how should we troubleshoot them. Then we can take a look at what should be prepared before the installation of this high-lift deep well pump. First, we must clean up the space and take out all the equipment, tools and other items.


高扬程深井泵

After turning on the light, check whether the high-lift deep well pump is damaged, and clean the information of this accessory randomly according to the list to see if it is complete. Before installation, the delivery period of this high-lift deep well pump should also be considered. If it is placed for a long time, the motor shaft and the pump shaft should be adjusted first so that they can rotate flexibly, clean and wipe the joint surface. If there are any defects that affect the installation, they should be corrected in time.

First of all, the motor and water pump need to be installed vertically, and the plane line and the flower line are set as the motor shaft. Then the seam is fixed on the motor to the groove, the fastening bolt is fixed, the pump shaft is rotated, the equipment is checked, how to rotate the flexibility, and then the motor and the cable are welded well, and the glue tape is used to prevent it and then put it into the water for 12 hours to have a look.

So let's take a look at what we should pay attention to before operation. First, check whether the circuit system is normal and see how the monitoring instrument is. Is this bolt loose? Turn the coupling, if it is good, then you don't have to take care of it. At the moment when the motor starts, check whether the direction is consistent with the steering of the water pump, otherwise, adjust the direction. Install the device in the roof and tie it tightly with cables. Do not tie it too tightly. It is appropriate.

So let's take a look, when thishigh lift deep well pumpWhen the machine is stopped, the sound pump should run for 2500 hours and be sent to the manufacturer or professional maintenance personnel for disassembly and maintenance. Check whether the wear is normal. If you need to start again, I hope to turn off the motor first. The time must be over 5 minutes before proceeding. If necessary, please contact us in time. Our company has many years of experience and looks forward to your joining.

Luohe Huali Pump Co., Ltd. specializes in the productionhigh lift deep well pump, Covering an area of 28.838 square meters, an enterprise integrating production and sales, has been serving the country since its construction in 1996. The pursuit of high quality products and this pursuit of service is our eternal purpose.